Tolerance Analysis using Monte Carlo, continued (Part 12 / 13)

In the case of the one-way clutch example, the current MC quality prediction for system outputs provide us with approximately 3- and 6-sigma capabilities (Z-scores). What if a sigma score of three is not good enough? What does the design engineer do to the input standard deviations to comply with a 6 sigma directive?

0 Comments
Article rating: No rating

Tolerance Analysis using Monte Carlo (Part 11 / 13)

How do Monte Carlo analysis results differ from those derived via WCA or RSS methodologies? Let us return to the one-way clutch example and provide a practical comparison in terms of a non-linear response. From the previous posts, we recall that there are two system outputs of interest: stop angle and spring gap. These outputs are described mathematically with response equations, as transfer functions of the inputs.

0 Comments
Article rating: 5.0

Tolerance Analysis using Monte Carlo (Part 11 / 13)

How do Monte Carlo analysis results differ from those derived via WCA or RSS methodologies? Let us return to the one-way clutch example and provide a practical comparison in terms of a non-linear response. From the previous posts, we recall that there are two system outputs of interest: stop angle and spring gap. These outputs are described mathematically with response equations, as transfer functions of the inputs.

0 Comments
Article rating: No rating

Introduction to Monte Carlo Analysis (Part 10 / 13)

In past blogs, I have waxed eloquent about two traditional methods of performing Tolerance Analysis, the Worst Case Analysis and the Root Sum Squares. With the advent of ever-more-powerful processors and the increasing importance engineering organizations place on transfer functions, the next logical step is to use these resources and predict system variation with Monte Carlo Analysis.

0 Comments
Article rating: No rating

Introduction to Monte Carlo Analysis (Part 10 / 13)

In past blogs, I have waxed eloquent about two traditional methods of performing Tolerance Analysis, the Worst Case Analysis and the Root Sum Squares. With the advent of ever-more-powerful processors and the increasing importance engineering organizations place on transfer functions, the next logical step is to use these resources and predict system variation with Monte Carlo Analysis.

0 Comments
Article rating: No rating
RSS
All Posts Author: Tyrone Smith

RESEARCH ARTICLES | RISK + CRYSTAL BALL + ANALYTICS